FinalProject.ng
FinalProject.ng › Blog › URP Guides › Similarity reports and academic integrity

What Is an Acceptable Turnitin Similarity Score for a URP Project?

Students often ask what percentage is acceptable before submitting a project. The correct answer depends on the institution, department, document type and the content behind the score. A number alone cannot determine whether academic misconduct has occurred.
By FinalProject.ng Editorial Team · Updated 18 October 2026 · 4 min read · Urban and Regional Planning

Students often ask for one “safe” number, but a similarity percentage only means something inside a particular institution’s rules. This guide explains what shapes the figure, who decides what is acceptable, and how to review a report responsibly.

Key takeaways

  • No single percentage is acceptable everywhere; your department or institution sets the standard.
  • Read what was matched, not just how much was matched.
  • Never remove citations or tweak formatting to move the number.
In this guide
  1. Why percentages vary
  2. What to ask your department
  3. Review the match, not just the number
  4. A practical review sequence
  5. Avoid score manipulation
  6. Ask for clarification early
  7. Illustrative example: two reports, similar scores
  8. Frequently asked questions
  9. Read next

Why percentages vary

A report compares text with material in the checker’s available sources. Reference lists, quoted text, standard phrases and close paraphrases can all contribute differently. Settings and source coverage also affect what is shown.

What to ask your department

Confirm whether your school has a written threshold, which sections are included, whether references or quotations are excluded and whether a supervisor reviews the matched passages. Do not rely on a universal figure shared on social media.

Review the match, not just the number

A lower score can still include an unattributed copied passage, while a higher score may include many properly attributed quotations or references. Examine source context, citation quality and the amount of original analysis.

A practical review sequence

First inspect the largest matches. Next check quotations and citations. Then review paraphrases and repeated passages. Finally confirm that exclusions and report settings follow institutional guidance. Keep the original report available for discussion.

Avoid score manipulation

Do not remove citations, replace words with awkward synonyms or alter formatting solely to change the percentage. Those steps can weaken the work without resolving attribution problems.

Ask for clarification early

If your department’s policy is unclear, ask your supervisor or authorised academic office before making major edits. Keep a record of any stated requirements.

Illustrative example: two reports, similar scores

Imagine two Chapter Two drafts that show a similar overall percentage. In the first, most matches are correctly cited quotations, sourced definitions and the reference list. In the second, the matches are long passages that follow one author’s sentence order with a few words changed. The numbers look alike, but the academic position is very different: the first may need only checks on quotation formatting, while the second needs rewriting and genuine synthesis. This is why supervisors look at the matched passages and not only the headline figure.

Frequently asked questions

Can a university set its own threshold?

Yes. Follow the applicable institutional or departmental policy rather than assuming a number applies everywhere.

Does a low score prove a project is original?

No. The report has limits and may not match every source; originality and attribution still require academic review.

Do references and quotations count towards the percentage?

That depends on the report settings used by your institution. Some reports exclude them and others include them. Ask which settings apply, and do not assume that reports run on different settings are comparable.

Who should I ask about the threshold?

Your supervisor or the project coordinator, ideally with the written policy, so that you work from the institution’s actual rule rather than something heard second-hand.

Further reading and related support

Further reading: Turnitin Similarity product information.

Departmental formats and policies differ. Your supervisor’s and institution’s current guidance always takes precedence over general advice.

Need help with your URP project?
Share your topic, programme level, university guidelines and deadline. FinalProject.ng can discuss available research guidance, editing, citation review and report options. Work should remain accurate, properly attributed and consistent with your institution’s academic-integrity rules.
Ask about URP support on WhatsApp